Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: jve on April 01, 2012, 05:20:23 AM

Title: rapid rate
Post by: jve on April 01, 2012, 05:20:23 AM
hi guys
i have my mill which it use to have an analog potentiometer that it will regulate the rapid rate and the feed rate instant which mach3 is not making i want to ask if this is possible with mach3 cause for setting up a new job this is very usefull the problem is that mach3 is looking forward the code and when i close the rapid rate it will take a while before it will come active also on the config page there is a box (look forward gcode) and mine is set 20lines if i set this to 0 lines does this come to instant active when i close the rapid rate to 0%