Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: lcvette on March 30, 2012, 05:10:30 PM
-
I have purchased both a touch plate and a digitizing probe and would like to use these to go through and set all of my tool lengths is possible (using TTS quick change tooling with Power Drawbar).
I had assumed it would be relatively simple to do but haven't found much information about it. a video would be very helpful if there is one out there but most i came across on Youtube were just showing it working not how to get there. Any help greatly appreciated!
Chris
-
There is a link in this thread that may help.
http://www.machsupport.com/forum/index.php/topic,21214.msg147512.html#msg147512
Brett
-
Hi,
All those features are supported in the MachStdMill package.
See www.CalypsoVentures.com for more info. The videos on the site demo how MSM is used for both tool TLO measurement during a tool change as well as the most extensive set of built in probing operations I'm aware of.
Disclosure: I'm the product's author, so you may consider my opinion biased, but MSM already does all that you mentioned.
Dave