Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: leozalewski on March 29, 2012, 10:38:07 AM
-
Hii
Get an "External Estop Requested" message all the time
If I change the active level of the Estop pin I then get the "Estop Button pressed" message
Nothing seems to clear the Estop ?
Have the same problems on 2 machines my office machine with no IO connections, my CNC mill with every thing connected
I use Pokeys for its IO, could it be causing this?
Increasing the switch debounce time has no effect
Any suggestions?
Regards
-
If you attach your xml I will have a look and see if there is an issue in your config.
Hood
-
Hi
Still have 2 machines with the same problem the eternial "External Estop Requested"
Regards
Leo
-
Assuming you have a normally closed E-Stop switch set up to pin 11 then it should work fine.
Hood
-
In config setup ports and pins make sure estop is enabled