Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: mwpeters49 on March 28, 2012, 01:48:05 PM
-
We are using a Mach 3 with CandCNC hardware. When we cut at higher speeds (200 ipm or more) the sharp corners of our cuts are rounded. We know there is a setting in Mach 3 to resolve this but the fellow who knew this software has returned to college and we don't know what he did to resolve this issue. Can anyone tell me how to fix this? :P
-
go to logic configuration screen , enter 89 as the number for stop cv, change cv tolerance to .1. this works for me.