Machsupport Forum
Mach Discussion => FAQs => Topic started by: Toddlock on March 24, 2012, 11:37:55 AM
-
I am very new to the Mach 3 software as well with my machine. I purchased a CNC 3040 machine and I downloaded mach3 to run it as the manual suggested. I followed the instructions in the manual to set up the ports and pins. I installed an after market parallel port in my PC. I found the address for this port and entered these addresses into the port setup and Axis selection. At that point I was able to jog all the axis, not very smoothly but they did move. I haven't changed any settings but now I can not get anything to jog.
Like I said earlier I am a newby and I am probable missing something easy. If anyHone. An help I would be greatly appreciated.
-
Todd, I'm sorry I missed this. Have you made any progress? You will probably get a lot more eyes on your post if you start a new one in the general discussion board.
Brett