Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: spr203 on March 15, 2012, 08:40:26 AM
-
hi i would like to know if anyone is using cnc4pc parts and if they are reliable . i am using this machine in a production shop . any in put would be great thanks
-
I use the c32 board with a smooth stepper with gecko servo drives with keling servos and the vmt encoders. Also the C5 board and a C45 board with hall effect switches and it all works great. With the charge pump and the following error set properly, we have always avoided catastrophic user error crashes.
-
I've been using the C10 board for over five years. No
problems.
olf20 / Bob
-
thanks for the replies looks good
-
If you want reliability and quality you cant get better than PMDX, that is just my opinion however so take it as you wish :-)
Hood
-
thanks hood, i did talk with them on friday . they seem to have a good handle on the system . got alot of info from them .
-
I am sure they are out there, but I have never heard of anyone getting a PMDX board that was bad?????
JAckal :)
-
If you want reliability and quality you cant get better than PMDX, that is just my opinion however so take it as you wish :-)
Hood
Yeah, Steve does make fantastic products. Very nice guy to talk to at the shows also...
I have CNC4PC products and they have been good to me.
-
what shows do you go to
-
what shows do you go to
I have talked to Steve at the Cabin Fever Expo show quite a few times.