Machsupport Forum

G-Code, CAD, and CAM => G-Code, CAD, and CAM discussions => Topic started by: Farmerjeff on March 13, 2012, 05:32:51 PM

Title: Circles in my Mach
Post by: Farmerjeff on March 13, 2012, 05:32:51 PM

Hello,
I am using Vectric and have Mach 2/3 arc txt* set as the post processor. When I upload an image into Mach, I am getting cirles (purple). The toolpath wants wants to follow these circles. It is not showing up on the Vectric (CAM). Once again as many before, thank you.
Jeff

Title: Re: Circles in my Mach
Post by: Overloaded on March 13, 2012, 05:44:20 PM

Hi Jeff,
  Check to see that Mach is in G91.1 Inc. I J mode in gen. Config.