Machsupport Forum
Third party software and hardware support forums. => PoKeys => Topic started by: samarkh on March 07, 2012, 03:43:49 PM
-
Will the PoKeys56 MachCNC plugin v 10.6.4 (3.1.2011) work with the PoKeys55, If so how?
If not what's the solution. I can't assign any values in the Mach 3 Pokeys Config dialog
Yours Simon M.
-
A new plugin is in works by PoLabs and will be available in approximately one month.
-
Thanks for that I'd almost given up!
-
NeoTO,
Is that the same one that Brian and I are poking at, on the SVN server? If so, there is a run time crash bug I am seeing on the Ethernet PK, But Brian says it is working with USB ok, (he test with USB, I am testing with Ether).
If you are on the SVN server, please remember to only upload code written in VS2003.
Scott