Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Signpro on March 02, 2012, 10:37:15 PM

Title: Question about speeds
Post by: Signpro on March 02, 2012, 10:37:15 PM

I'm having a bit a confusion regarding the speeds set in Mach3.  

I went into the config and set the max speeds and all that good stuff, but I don't understand the relationship between that and the CAD software settings. Is the speed controlled by Mach3, the CAM software, or both?

Title: Re: Question about speeds
Post by: Hood on March 03, 2012, 03:21:11 AM

Both
G0 are what you set in motor tuning as your velocity.
G1, G2 etc with a F*** will move at the F rate you have set.

Hood