Machsupport Forum
Third party software and hardware support forums. => LazyTurn => Topic started by: zeeschuim on February 26, 2012, 03:33:13 AM
-
what is wrong?
-
Please post the dxf file.
RICH
-
here it is
-
stick around and i will have a look at it
RICH
-
Hmm....let me play with it some.
The first thing is that on import it is not comming in at Z=0, then it will gouge on a rough.
It is a polyline and that may be the problem. I say in the manual not to use them.
Need to fool with it.....so will post l what i find.
RICH
-
Try my dxf as it's just a redraw of yours and it works as shown below.
RICH
-
I found it, it was 0.001mm on the wrong side off the X zero point
-
thanks Rich!,
Cees
-
Glad it's working for you.
RICH