Machsupport Forum
Third party software and hardware support forums. => dspMC/IP Motion Controller => Topic started by: scrambled on February 23, 2012, 06:11:37 PM
-
Can the dspMC/IP do step and direction?
The manual say it is not supported "Yet". Any ideas?
Steve
-
we just launched a new board that support step/direction
www.vitalsystem.com/hicon (http://www.vitalsystem.com/hicon)
some time this year we might be able to add step/dir in dspmc. sorry I cannot give you more precise information at this time.
regards,
Rufi
-
we just launched a new board that support step/direction
www.vitalsystem.com/hicon (http://www.vitalsystem.com/hicon)
some time this year we might be able to add step/dir in dspmc. sorry I cannot give you more precise information at this time.
regards,
Rufi
Rufi,
Any chance of getting Step/Dir added to the DSPMC? It has been a long time.
-
According to the web site there is now Step and Direction support.