Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: skaha on January 01, 2007, 04:37:53 PM
-
I finally have my desktop up and running, I have cut roadrunners into every available piece of wood I could find, I find it hard to believe everyone is going out and spending 6 or 7 hundred dollars and up for cadcam programs, I have spent countless hours surfing the sites and now am completely confused. Help.
Terry
-
Lazy Cam is free with Mach. ;D I haven't used it but a lot of others have.
Brett
-
Thanks Brett, I confess I don't know much about this area, but I will dive into lazy cam.
Terry
-
Brett, I just sat and watched the videos on lazy cam, I guess I just have not explored all that mach is offering, it turned the lite on a lot of questions I had. Thanks again.
Terry
-
Your welcome Terry,
The learning curve is only part of the infatuation. ;D
Brett
-
Wurde ;D