Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: msimpson on February 12, 2012, 01:08:31 PM

Title: Mach 3 slave tweaking question
Post by: msimpson on February 12, 2012, 01:08:31 PM

I am setup to have A axis slaved to Y axis. I was wandering if there was a way to tweak the A axis by its self? (Even while it is still slaved to Y)

Title: Re: Mach 3 slave tweaking question
Post by: iv-cnc on February 16, 2012, 08:17:39 AM

No, you can't have different settings for slave axis.
You have to touch the parameters of your servo drive.
(Usually they have 2 paramterers like: "electric gear numerator" & "electric gear denominator")

John