Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: mancman4 on February 12, 2012, 06:24:25 AM
-
I have a problem when cutting circles about 25mm in diameter.
The problem is the circle has a small flat spot on one side.
I have tried slightly different size circles 20mm & 30mm and it appears on all of them.
I am using VCarvePro to generate my G Code to a Proxxon MF70 CNC controlled by Mach3.
Not sure whats causing it so any help is appreciated.
Thanks
Jason
-
Check youp backlash. You may have a little more in that area of your table. The extreme would be some pitch error in your lead screw.
Hal
-
Thanks for the reply Hal.
I'll check for backlash and see if that cures it.
Jason