Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: JED022660 on February 08, 2012, 05:26:12 PM
-
FIRST OF ALL THANKS TO EVERYONE WHO ANSWERS MY POST, YOU HAVE BEEN A GREAT HELP!!!
M question for the day is; I am trying to engrave Mfg's ID & SN's on Aluminum parts. I have selected the font and size, have generated the g code, and have dry run the program. the issue is that my engraving tool is traveling along the outline of the letters in the text. I need ti scribe over or engrave ON the line of the text as opposed to the outline. Please help! Thanks again!!!!!! ???
-
That will be your CAM that has to do that, what are you using for CAM?
Hood
-
HOOD,
Ion this particular program was creaed using PH CAD to produce the DXF file then using LCam for writin the G code.
-
Perhaps you inadvertantly chose to OFFSET in LCam ?
Otherwise, it should cut ON the lines.
Russ
-
You need single line fonts. Try using Stickfont. http://www.ncplot.com/freetools.htm
-
How about the Write Wizzard. It will give you one line at a time.
Hal