Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Flyrobby on February 07, 2012, 11:08:05 PM
-
When scrolling through the gcode I no longer see the location of the tool in the toolpath screen (or the part of the toolpath that represents the gcode doesn't light up) like I used too, I don't see where that can be turned on or off, do I need to reinstall Mach???
-
What version of Mach are you using?
Hood
-
Maybe you are getting the same as I am. Please check:
http://www.machsupport.com/forum/index.php/topic,20711.10.html
-
After I posted this I asked myself the same question and I AM do for an update, if the problem perstis after that I'll be back.
Sorry ftom not the same problem.
-
New version fixed it.
-
That did NOT fix my issue, I do have the latest ver, I know it used to work, did I turn this off somehow??
-
attach your xml and some code that you have issues with please.
Hood
-
I tried renaming the files but I keep getting this message, what do I need to do? Sorry! There is already an attachment with the same filename as the one you tried to upload. Please rename the file and try again
-
Copy it to your desktop and give it a different name, like none before.
Same with ANY file, must never match a previously sent file name.
-
Thanks overloaded. Hope this is what you needed Hood. Thanks
-
Would seem the issue is with the A rotations Enabled setting, I disabled it and regenerated the toolpath and then when stepping through the code the lines show up. You get that setting from Config menu the Toolpath.
Hood
-
Thanks Hood, I have been messing around with my 4 th axis recently. I really appreciate your help and thanks for your patience.