Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: vbmw002 on February 05, 2012, 10:28:33 PM

Title: Motion abnormalities
Post by: vbmw002 on February 05, 2012, 10:28:33 PM

In the use mach3 control 4 axis engraving and milling machine, Yaskawa servo motor sports, motor frustrated phenomenon is what causes?

Title: Re: Motion abnormalities
Post by: Hood on February 06, 2012, 02:47:16 AM

Not a clue what you are asking I am afraid, you will need to try and explain what your problem is.
Hood

Title: Re: Motion abnormalities
Post by: vbmw002 on February 06, 2012, 02:56:51 AM

MACH3 which set the maximum speed of the servo motor is 3000mm/min the acceleration 1500mm/ss finish roughing code, finishing code motor frustrated phenomenon, the movement is not smooth.

Title: Re: Motion abnormalities
Post by: vbmw002 on February 06, 2012, 02:57:43 AM

Quote from: Hood on February 06, 2012, 02:47:16 AM

Not a clue what you are asking I am afraid, you will need to try and explain what your problem is.
Hood

MACH3 which set the maximum speed of the servo motor is 3000mm/min the acceleration 1500mm/ss finish roughing code, finishing code motor frustrated phenomenon, the movement is not smooth.

Title: Re: Motion abnormalities
Post by: Hood on February 06, 2012, 04:47:13 AM

Not much to go on and really still not sure what you are meaning but my guess would be that your issue may be the servo tuning in your drive.
Hood