Machsupport Forum
General CNC Chat => Show"N"Tell ( Your Machines) => Topic started by: rslengineering on January 24, 2012, 06:10:04 PM
-
I have just replaced my hypertherm 45 with a new 65 model, this one also has a machine torch and i have ordered it with an ohmic sensor. Could somebody please help with wiring and settings as i know a wire goes to the ohmic sensor and another wire goes to the workpiece but that is it. I have trawled through pages and pages of internet searching, looking for a diagram but i cannot find any. I use mach3 and sheetcam if this helps
Regards Richard