Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: atwooddon on January 24, 2012, 05:51:29 PM
-
I have some 3D software that is outputting feedrates with a comma (ie F1,000) which Mach 3 is interpreting as F1 (F1.000). Is there a setting Mach3 that tells it to use a comma the same as a period? I thought I saw it once upon a time or read about it here on the forum but can't seem to find it in setup or searchs here on the forum.
Thanks
Don
-
You might have to fix that in your PP.
Dont recall seeing a setting for that within Mach.