Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: v tec on January 08, 2012, 07:53:36 AM
-
hi, i would like modify this plug in:
http://www.machsupport.com/plugins/JCode.m3p
it s the jcode plug in
http://www.machsupport.com/plugins/JCode.m3p
because it write only the xyz axis, and not the xyzabc axis
but i don t know how to do
and if someone know how to work this plug in, because i don t understand for record each xyzabc position line by line
-
Modifying a plugin would require you to have the source code and I am not sure if Brian has released it or not.
Yopu may have more luck with the copycat wizard, I have not tried it but if it doesnt have access to the A B C DROs then you can likely change the button script in the wizard.
Hood
-
maybe we can suggest at brian, to add abc axis
to add button
one for write in the code at the last line
one for insert the code between line
if someone know brian
-
Brian is the guy that now writes Mach, he is a bit busy normally ;) If enough people wanted it then I would imagine it would go on the list of things to do but I am not sure it would be high on many peoples list of wants.
Hood
-
i understand, but how to help him?
-
Best thing to do would be send a request to andrew@machsupport.com and see if it gets on the list. It may be it is a very easy thing for Brian to modify or it may be it is a very hard thing, only Brian will know.
Hood
-
mail sent
the best for this plug in will
start a new file blank
adjust the position for all axis
click on a button for write all position with the good position
exemple
g0x10y5z8a-5b10z300
after continue to adjsut the axis, write the second line with jcode
etc....
and if you need to insert a line before the line *********, you can use an other button
with this plug in, you can program a arm robot, finger in the noze ^^
-
after test, copycat is fine, easy to use it
but only 3 axis