Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: rrrevels on January 02, 2012, 09:53:59 PM
-
A friend contacted me about a problem he created in Mach3. He said his Feed Rate is locked at 2.3 and the over ride button flashes. I have tried to come up with ideas of what may have happened but am at a loss.
Anyone have any ideas of where to look?
Thanks,
Russ
-
Post the xml file he is using and someone will have a look and see what's up.
RICH
-
I am waiting for a copy of the xml file and will post. Hopefully tomorrow.
Thanks,
Russ
-
I never heard back from the friend and finally had a chance to go see him Monday. His problem was simply a bad feed rate in the cut file. I edited the file and told him how to correct it in his source and everything is fine. His inexperience caused a lot of unnecessary questions.
Russ