Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: zoe on December 24, 2011, 10:11:01 AM

Title: Help !!..New to CNC .. KX3 question and mach3
Post by: zoe on December 24, 2011, 10:11:01 AM

Hello all...

 This is my first post. I am new to CNC and just purchased a sieg KX3 and have a question. Is it possible to use Mach3 with the Sieg KX3 that has a Cat5 interface instead of the parallel port. If so how do I go about it. I have google and searched everything I know. Thank you for any help in advance

Zoe

Title: Re: Help !!..New to CNC .. KX3 question and mach3
Post by: jeremy0203 on December 24, 2011, 10:53:32 AM

check out the ethernet version of the smoothstepper.

Title: Re: Help !!..New to CNC .. KX3 question and mach3
Post by: zoe on December 24, 2011, 10:57:15 AM

Thank you... Should i just google search and download ? I appreciate your help.. thank you

Title: Re: Help !!..New to CNC .. KX3 question and mach3
Post by: zoe on December 24, 2011, 10:58:10 AM

oh I see it is hardware.. I will look into it..