Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: vivamach3 on December 17, 2011, 01:11:16 AM

Title: first help
Post by: vivamach3 on December 17, 2011, 01:11:16 AM

Ho to all

I am new in this forum and mach3 software.
It is very good software but i am new and need your help.
I saw some tutorial video but i can't run my step motor.
Can you please help me for below questions:

1- When i test the drive it show me below error :

link deleted by Stirling

when i click on special driver it show me below error :

link deleted by Stirling

what should i do ?

2-  setup my pin and port also please sea below file and tell me does it true or not?

link deleted by Stirling



I am wait for your reply.


Thank you

Title: Re: first help
Post by: vivamach3 on December 17, 2011, 02:00:02 AM

Hi

I remove and install again the maxh3 software and the driver test show ok:

link deleted by Stirling

Can you please sea my XML file and tell me what setting is incorrect? why i don't have motor rotation?

Title: Re: first help
Post by: stirling on December 17, 2011, 07:58:11 AM

So you think that by changing your user name we'll help a pirate?

User banned

Title: Re: first help
Post by: RICH on December 17, 2011, 08:39:12 AM

You are using a pirated Mach version. We do not condone or "support" that activity.
You will not recieve any support or additional replies from this site.

RICH