Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: jonny quest on December 10, 2011, 07:10:08 PM

Title: problem with a post processor
Post by: jonny quest on December 10, 2011, 07:10:08 PM

my Z is moving up so it will just cut air... attached is post processor file and I'm just pasting first lines of code

G00 G49 G40.1 G17 G80 G50 G90 G64
G20
(.25 Flat faced Center cutting 4 flute HSS)
M6 T1
M03 S2000
G01Z0.000
G01X-0.229Y0.541Z1.017 F60
X-0.185Y0.525Z1.010 F60
Y0.568Z1.003
X-0.449Z0.961
X-0.625
Y0.525
X-0.581Y0.541
X-0.537Y0.553
X-0.518Y0.558
X-0.493Y0.562
X-0.449Y0.567
X-0.361Y0.567
X-0.317Y0.562
X-0.293Y0.558
X-0.273Y0.553

Title: Re: problem with a post processor
Post by: jonny quest on December 10, 2011, 10:38:34 PM

i think i have it figured out. post seems fine... drawing wasn't in a correct position... gave funny gcode results