Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: bshaker1 on December 24, 2006, 06:07:52 PM
-
I saved mach3 ver2.0.009 update install onto my desktop, but when I go to install it keeps coming up with an error cannot decomprees setup program
-
Tried downloading again?
Hood
-
I've tried several times with no results. I just purshased a new computer to run my mill. I have a liscensed version on my destiop and trying to put it on my new computer, version 1.84.002 downloaded with no problem but now I'm stuck
-
Strange, I just downloaded and reinstalled it no problem. Dont think this would cause that error message but just in case make sure you have admin rights. Another thing, are you actually downloading with the new computer? maybe transferring from a CD or other data source is corrupting it. Try downloading on a different computer and installing it on that (if you have one handy)
Hood
-
I've tried on 3 other computers they all including the new say that the program has been saved but when I try to run another error comes up that microsoft has encoutered a problem and you know the rest
-
Found my problem. Since the download affected 3 other computers it finally hit me that it might be my network. I unplunged my ISP cable from the network and pluged it directly into an independent computer and bingo.