Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: gda on December 06, 2011, 01:20:40 PM

Title: Mach 3 under 64 Bit?
Post by: gda on December 06, 2011, 01:20:40 PM

Will Mach 3 run in 64 bit mode?

Title: Re: Mach 3 under 64 Bit?
Post by: Hood on December 06, 2011, 03:48:08 PM

Mach itself will but the driver for the parallel port output wont so you would need to use an external controller such as the SmoothStepper, DSPMC, Kflop etc

Hood