Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: dresda on December 06, 2011, 01:36:52 AM
-
I activated the 3d plugin and when I set up the parameters a box pops up and says test the probe and when I do the tick goes in the box so the probe is working.
I cycle start, the xy moves then the z, I touch the probe and then I get a box saying "previous sequence not yet met" can't get rid of it' can't stop the program or reset, have to kill the machine, any ideas.
Ray.
-
Hi Ray,
You are not alone here, I get exactly the same thing with version R2.043.022.
The message box "previous sequence not yet complete" is just an error message from probing plugin code but I have to shutdown to clear it as well.
No help but lots of sympathy :)
Tweakie.