Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: don carpenter on December 23, 2006, 08:51:58 PM
-
I just found this wonderful site a couple days ago and am now trying out the latest locked down version of Mach 3 (rev 2.0.029). The latest users manual that I can find is for rev 1.84. Is there a later version?
Also on page 3-10 of the Mach 3 Mill manual there are references to the Start Cycle, Pause, Stop, and Rewind buttons. I see an Cycle Start and a Stop button but not the others. Where is Pause and Rewind?
Thanks
Don
-
Dont use the standard screen so not 100% sure but last time I looked they were still there, the pause will be called Hold but the rewind is still rewind.
Hood
EDIT
OH also as Mach3 has just recently been locked down there is no final manual but I think John P may be busy working on it.
Hood
-
Just loaded that standard screen and they are still there, see pic.
Hood
-
Thanks... I guess I am just blind in one eye and can't see out of the other. :)