Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: MKroe on November 27, 2011, 05:41:50 PM
-
Hi all,
Have been a lurker here for a long time. I have been using M3 for awhile now and have been using plasma mode for over 6 months when doing 2.5d, as well as arcs and such. This tends to eliminate the jerky point to point cutting when milling at high feedrates.
Now My question, Is there a way to call plasma mode with Gcode, Using say an M or G call? I have a need to change from CV or exact stop to Plasma and back during some milling. I can use G61/G64 call from Exact stop to CV but that does not accomplish what I need
thanks
MK
-
I don't know of any way to turn on the CV plasma mode OTHER than the Genconfig window.
(;-) TP
-
That's what I'm think as well BR549. It would sure make things easier though for me if I can. :)