Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: sndpntlynch on November 19, 2011, 11:27:46 PM
-
I have just purchased a new computer. There is no 25 pin printer port on new computers. I have found a 25 pin parrallel to usb adapter. will this work for pluging in to my geco drives.
-
No. If all you have is USB, you'll have to buy a USB motion controller, like SmoothStepper, KFlop, Galil, etc.
Regards,
Ray L.
-
Or by a PCI parallel port card for $25
-
or even cheaper if you shop around. I've tried about thirty different parallel port cards from £1.50 to £30 and all have worked.