Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Igloomason on November 11, 2011, 05:12:40 PM
-
I have a Handy Pulser MPG that works fine with a Brain except when I switch between axis. More often then not, the jogging will be turned off and I'll have to turn it back on before I can use the MPG. All axis work fine, it's just the switching between them that causes problems. I'm worried it's a hardware issue but thought I'd ask to see if anyone has any suggestions.
-
Whats in your brain? How do you change axis?
Hood
-
I didn't install the Brain or the MPG but I am relatively certain it is the one attached. I read the manual and all my pins seem to be configured correctly. There are two additional Brains in my directory, one appears to be a slight variation of the attached. Should I disable it? My axis is changed with a knob on my MPG as is the feed-rate.
-
Are all the Brains enabled or is it just this one?
Hood
-
All three Brains are enabled. I tested each one individually with the others disabled and I get much more reliable performance with only the last (the one I attached) enabled. I only have one MPG, what would I be messing with to disable the other two?
-
I havent looked at the brain yet but if you can also attach the others I will see what they are for when I get home from the workshop.
Hood