Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: air2gnd on November 08, 2011, 06:09:26 PM
-
I have a question? Is it possible to control 2 cnc machines from 1 pc? Not at the same time. Do I create two separate profiles for each machine? Thanks
-
Air2gnd,
I use one PC that runs a lathe and a mill and since I have two profiles for the mill I would say yes to your question.
To make even more useful I use the same stepper drives, same PC, same IO board. To control the steppers I use a DT4P switches.
-
My PC and controller sits on a movable cart since the machines are located in different places but you could use a switch box if stationary.
Each machine has a profile since they are all different.
RICH