Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: borrisl on January 31, 2006, 08:29:25 PM

Title: No toolpath display after 1.90 installation
Post by: borrisl on January 31, 2006, 08:29:25 PM
After installing 1.90, non of my toolpaths display in the graphics box.  The green, toolpath trace shows up during machining, but nothing apears from regen toolpath.  Anything I am doing wrong?
Title: Re: No toolpath display after 1.90 installation
Post by: Art on January 31, 2006, 08:58:19 PM
Hi:

 Hmm, check the toolpath config. Did the coloutrs get set to black or something?
Title: Re: No toolpath display after 1.90 installation
Post by: borrisl on January 31, 2006, 10:02:14 PM
Nope.
Title: Re: No toolpath display after 1.90 installation
Post by: Art on January 31, 2006, 10:22:26 PM
Is the file a series of G81'sd only? They may not display much other than red lines to get there. Load the roadrunner, does it display??

 Art
Title: Re: No toolpath display after 1.90 installation
Post by: borrisl on January 31, 2006, 10:39:58 PM
No display with road runner.  It's naked!!!!
Title: Re: No toolpath display after 1.90 installation
Post by: borrisl on February 01, 2006, 01:14:41 AM
Now I have 1.84 with no toolpath display.  Wonder if I should employ the uninstall, clean, and reinstall option?
Title: Re: No toolpath display after 1.90 installation
Post by: Brian Barker on February 01, 2006, 06:45:03 AM
Try to double click on the graphic screen. This will tell it to redraw...
Title: Re: No toolpath display after 1.90 installation
Post by: borrisl on February 01, 2006, 12:46:23 PM
I don't know what the problem was, but I uninstalled, deleted the Mach3 folder, deleted anything I could find in the registry, and then reinstalled.  Now, life is grand. 
Title: Re: No toolpath display after 1.90 installation
Post by: John S on February 01, 2006, 04:45:37 PM
Black hole ??

John s.