Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: engineeron on October 23, 2011, 01:45:30 PM
-
I can jog in one direction only. I replaced the BOB (DB25) recently and i also replaced my computer because the mother board was fried.. The Y would reverse for a while but when I made some changes it will work only one way now. All seems ok in the program but may not be. Help Help
-
Either bad wiring for the Dir pins, bad bob or you do not have the correct pins or ports assigned for the Dir pins.
Hood
-
I have all axis working in both directions Now ..except the X axis. I have checked and rechecked ports and pins setup and all checked to specs. I was wondering if one wire is wrong on the bob. It maybe something simple. Help
-
If you have a spare output on the BOB rewire the X Dir to it and re-assign in Ports and Pins, Motor Outputs to that pin and see if it helps.
Hood
-
Thanks for the help... It worked. I changed the wires on BOB for the X dr. from 2 and 3 to 8 and 9 :)
-
:) good you got it :)