Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: N. F......LUCK on October 21, 2011, 12:11:48 AM

Title: were tp look?
Post by: N. F......LUCK on October 21, 2011, 12:11:48 AM

Hey guys,
  I'm new to the forum.I had my router up and running,jogging playing around with It when all a sudden I lost my X Y movement.The Z still works.I ran the X Y leads to the z one at a time and the motors work.To day I changed out the board with a new one.Still the same problem only Z runs.When I turn it on all the motors set the brakes,but will not jog! Just the Z jogs.Any Ideas?

Thanks Randy

Title: Re: were tp look?
Post by: Tweakie.CNC on October 21, 2011, 03:16:48 AM

Hi Randy,

Some more details on your setup would be useful.

What type of breakout board and stepper controllers are you using ?

Have you checked that the step and direction pin settings within Mach are correct for the X and Y axis ?

Also - check your keyboard regional settings as the X and Y jog keys (arrow keys) may not be operating correctly.

Tweakie.