Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: dsplastx on October 17, 2011, 01:29:40 PM
-
Hello friends i received mu machine today and i hawe a problem i need to build a DB25 Male to DB25 Female Parallel Cable.
Because i hawe Male on controler and Female on Desktop.
Please can somebody with more expiriens help and send me som shematic so i dont make a mistake i hawe already bu a male and female conector and cable.
I wud bu it wery well but in mu town they have onlu Male to Male .
Thanks in advans.
-
Just connect pin for pin, the numbers of the pins will be on each connector so 1 to 1, 2 to 2, 3 to 3 etc
Hood
-
Thank you very much i soused that they all parallel but i don't no that i haw to connect all of they 25 so you say that doesent mather.
And please if its not a problem i haw read on controller that is some omega systems 3 axis controller and i don't understand and i don't ha we no driver received wit him .
Do i need some additional driver or will that do the Mach3 bu him self.
Thanks again and sorry for mu treble English.
OO that spell check is great now is great.
-
I am sorry I dont know what you are asking :(
Hood
-
OK i will true .
I with the machine i have also received a motor control box with controller.
In the box is some OMEGA SYSTEMS controller.
But i have not received any driver for the controller.
Now if i connect the controller on mach3 Vile the software find the driver file.
-
Do you have a link to the controller you have so that I can see?
Hood