Machsupport Forum

Third party software and hardware support forums. => Third party software and hardware support forums. => Topic started by: crob09 on October 12, 2011, 07:23:48 PM

Title: I need help with a post processor for Phidgets, any info would be appreciated
Post by: crob09 on October 12, 2011, 07:23:48 PM

I was wondering if someone could help me figure out how to make a post processor for a 1062 4 motor controller manufactured by Phidgets.

I really have no idea where to begin so any help undertanding how the post works is greatly appreciated.
Also is it even possable to have a post program for a USB device?
I will be posting any finds here and on my website at http://www.cncstuff.com and you can email me at admin@cncstuff.com

thanks for your help and time.

CNC Phidgets Post processor
CNC stuff
CNC mill
CNC lathe
http://www.cncstuff.com