Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: fragger6662000 on September 28, 2011, 05:54:32 PM
-
Gent's and ladies
I have been using mach for many years but just using the base co-ordinantes without using G54 or G28 commands, I don't see the need to run them on this machine as i don't have multiple setup on the machine and no repeatable tooling for length.
anyway i have switch to a different cam which uses g28 and g54 and i have a lathe setup and mill setup on the same machine.
When i exit and save fixture and reload it now does not remember the position.
Or is it just showing the g53 and not the g54 wcs?
thanks matt
-
The DROs show G54 by default, G53 is only seen when you have MachineCoOrds button active.
Have a look at General Config page and see if you have persistent offsets and DROs chosen.
Hood
-
i will hava a look.
thanks
-
seam tohave had that selected. another hood rescue!