Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: vtx1029 on September 24, 2011, 10:17:17 PM
-
My Y axis runs opposite of the normal configuration. Is there a way to flip flop the y jog buttons?
-
If you press the Up Arrow your tool should move in a positive Y direction in relation to your work piece and the DRO should count positive. If it is doing that then it is correct, if it is not then you can change by going to Config menu then System Hotkeys and clicking on Y++ and pressing the Up arrow then Y-- and pressing the Down arrow.
Hood