Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: cpayne on September 22, 2011, 03:19:13 PM

Title: 4th rotaray axis
Post by: cpayne on September 22, 2011, 03:19:13 PM

Hi.  I am finishing up a 4 axis CNC router table. The forth axis is a rotary table.  I have it working, but in the motor tuning, I do not want inches per pulse, I want dgrees per pulse.   I also want to the readouts to be in degrees instead of inches.   Is there a way to do that?

Thanks,
Charlie

Title: Re: 4th rotaray axis
Post by: Hood on September 22, 2011, 03:31:53 PM

Config menu General Config, set A as a rotary axis.
Hood