Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: atatro on September 21, 2011, 12:06:14 AM
-
I have an older torchmate plasma table that I would like to upgrade to Mach3. I was wondering if anyone here has done this. I'm looking for some info on a good place to purchase the motors and driver board as well. Any help with this would be great.
-
The person you NEED to talk with is Tom Caudle over at CandCNC. HE is the expert on Plasma table conversions.
(;-) TP
-
Looks like a good way to go. Has anyone here used his set-up? Thanks
-
atatro i am wondering how you made out with your conversion ???