Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: ErrorFinn on September 17, 2011, 02:01:18 PM
-
I bought some days ago, a used Proxxon MF70 with Usovo cnc 2008 kit, now i want use it with Mach3 software. I got only a assembly instructions, and now i need correct "pins" and other configuration data. The "default pins" are not working, after many hours of trying, i get some movement, but...
-
If you load up the original control software it should give you all the pin in/outs in the machine configuration page, all you need to do is then assign them in Mach3's ports and pins.
-
Wel after some hours of searching the problem, I figured out that I had to change Estop pin#10 to pin#11
Then I press on the Mach3 RESET button, then Estop changed to Idle, after that I'll get the stepper motors working.