Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: ballistic31 on September 16, 2011, 06:36:07 AM
-
well question #1 is when i update if i install it over the existing version will i loose my licence file.
The reason for the update is due to this version i have is very quirky.......probes crash you have to press the normal condition button 5 times a run. The tool numbers never worked right when you call a tool change
you have to manualy change it in the dro and hit enter. I have lived with it for years now lol. I recently downloaded a new version and tool numbers change when they are supose to and what not lol. I just wanted to make sure when i install it over the top of my working one in my shop im not stuck with a demo after all is said and done. thanks for your help
-
The licence should be fine as also your profile etc should be but its always a good idea to keep these things backed up anyway .
Hood
-
Thank you hood you have been very helpfull. I am hopeing this will fix all the bugs in this setup. I think the download im running now is from 3 or 4 years back lol.
JOHN
-
Well that worked perfect all is in order now the lathe side of mach works. Tool #s change as they are supose to just needed an upgrade is all........The probe crashes where my fault lol seems when i put the capacitor in for the probe i wired it to the E stop pin silly me lol . The keling digital drivers i just installed are very nice indeed.
-
Glad to hear all is well :)
Hood