Machsupport Forum
Support => Downloads => Post Processors => Topic started by: robertmonroe on September 15, 2011, 06:37:07 PM
-
I can't believe there is no official Mastercam Post. It's ridiculous, really!
I used the one that is floating around but it has some problems.
-
Doesn't Mastercam have a post processor for Mach3?
One would think that Mastercam would provide one or the ability to create one, if not , then Mastercam is ridiculous! ;)
RICH
-
I would say call your local rep. If you bought Mastercam you shouldn't have an issue getting it working. What exactly is not working in the standard Fanuc post?