Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: MikeHenry on December 15, 2006, 11:44:11 PM

Title: Mach3 vs Mach2 - benefits
Post by: MikeHenry on December 15, 2006, 11:44:11 PM

Is there a link to a page that describes the differences between Mach2 and Mach3?

I have a Tormach mill which uses Mach2 and am wondering what upgrading to Mach3 might get me.

Mike

Title: Re: Mach3 vs Mach2 - benefits
Post by: Hood on December 16, 2006, 04:44:18 AM

Dont think there is a page that describes the differences :(
 Best thing to do is download and install Mach3 and mess around with it without setting it up to run your mill. That way you can see what it looks like and it will giove you an idea of the differences. You can have Mach2 and Mach3 on the same computer and they wont interfere with each other, only thing you cant do is have both open at the same time.
Hood

Title: Re: Mach3 vs Mach2 - benefits
Post by: MikeHenry on December 16, 2006, 12:37:39 PM

Thanks Hood, I'll give that a shot.

Mike