Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: BR549 on September 09, 2011, 01:32:15 PM

Title: G73 Pullback setting
Post by: BR549 on September 09, 2011, 01:32:15 PM

Could someone verify that the G73 pullback setting is NOT being saved in the XML when you change it .

Config , port/pins, mill options, lower center of window.

Thanks (;-) TP

Title: Re: G73 Pullback setting
Post by: Hood on September 09, 2011, 02:11:35 PM

I am sure I have seen mention of that before and have just confirmed it is the case.
Hood

Title: Re: G73 Pullback setting
Post by: Mats on September 10, 2011, 06:44:57 PM

It is not saved. It looks like the XML file is updated with the value 0.1 when you exit Mach3.