Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: shucks on September 08, 2011, 06:11:41 PM
-
We are new to this. Sorry if this is a stupid question!
Why are we getting our pattern imported from sheet cam into MACH roughly over twice the size of the original pattern? We are using this software for a plasma table. Help would be appreciated
-
DO you have scale set in MAch3?
DiD you scale going into SheetCam?
DID you verify the size from CAD?
What did you import into Scam as ? DXF?SVG?
Justa thought(;-) TP
-
thanks, we'll check those.