Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Tony Woollacott on September 05, 2011, 03:06:20 PM
-
I have finally got round to putting home switches on my machine, but have a problem with the X and Y axes activating the Estop rather than homing. The Z axis seems fine and both the X and Y axes light up the led's on the diagnostics page. The actual Estop also works fine. Any body got a clue whats happening? ???
-
Sounds like electrical noise, you could try setting a Debounce Interval of 2000 and see if that helps but best idea is to shield and properly ground the wires if you have not already done so.
Hood
-
Thanks Hood, that got it, all is now perfect!!!!!