Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: DaOne on August 28, 2011, 12:57:48 AM

Anyone know if cutter compensation (tip radius) works in turn? This is G40  G42. If so maybe someone could give me an example because the fanuc code I have used doesn't appear to activate it. ???
Thanks,
Wes

Well after searching the forums it looks like this still hasn't been fixed? Maybe I am wrong? Maybe someone else can confirm this? If it is indeed screwed up still I will be removing the option from my screen set. Might see if I can figure out the math on this for the wizards. Anyone have any equations?

I think I got the the math figured out so far... gonna give it a shot :)