Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Figula on August 19, 2011, 05:36:12 PM

Title: Master and Slave not in sink?
Post by: Figula on August 19, 2011, 05:36:12 PM

Hi All, Why does my slave axis "A" end up .5" off Home after running a file or jogging around. And is it possible to set the steps of the slave. I'm a Joe's cnc 4x4 builder.
Al

Title: Re: Master and Slave not in sink?
Post by: BR549 on August 19, 2011, 06:13:39 PM

Are your motor settings the same for both axis Master and Slave?  Steps per/ accel/ vel ????

(;-) TP